Auto-meter 6806 Bedienungsanleitung PDF herunterladen

Connector

Probe Trigger

Adjusting Nuts

⁄4” Thick

Minimum

⁄4” Thick

Minimum

Should protrude at least

⁄8” from disc surface.

⁄2” Wide

⁄16” Deep

Bracket to Hold Probe

(Not Provided)

Steel Cap Screw with

head dia. of

⁄16” to

⁄4”

Either Aluminum or

Steel Disc

(Not Provided)

Either Steel or

Cast Iron Disc

(Not Provided)

A. Raised Screw Head Disc Method

B. Grooved Disc Method

.030” to .050”

INSTALLATION INSTRUCTIONS

6,000 RPM MEMORY TACHOMETER

2650-1111

Mounting

Wiring

Probe Installation

Connect the tachometer wires as shown here. All wires passing

through the firewall should be routed through the rubber grommet

provided. If a splice connector is used, be sure to make the

connection inside the car’s driving compartment.

Splice

Connectors

(provided)

White

Black

Red

Ribbed

Smooth

Connector

Probe Trigger

12V Lighting Circuit

Ground

12V

Black

White

1. Disconnect the connector from the

probe trigger.

2. Insert the threaded end of the probe

trigger into a bracket (not provided) and

secure it with the two adjusting nuts

(provided) as shown.

3. With engine off, screw the probe trigger

in until it touches, then back off

⁄2 to

⁄4 turn, leaving a .030” to .050” gap

between the end of the trigger and the

disc or screw. Carefully tighten the

adjusting nuts, taking care not to allow

the probe trigger to turn.

4. Reattach the connector to the probe

trigger.

The special design of the tachometer base allows

for a variety of mounting possibilities. Attach the

base using screws provided or use pop rivet tool.

Four Equally

spaced slots 90˚

appart.

CAUTION!

As a safety precaution the Red wire of this product should be

fused before connecting it to the positive (+) side of the 12V DC

battery. We recommend using a 4 Amp, 3AG fast-acting type

cartridge fuse (Littlefuse

# 312 004 or an equivalent) inline with

the Red wire of our product.

Questions?

If you have questions regarding the operation or installation of

your instrument(s), please contact Auto Meter Technical Support

at 815-899-0801.

You may also email us at [email protected]. Addditional

information can be found at http://www.autometer.com.

1 2

Inhaltsverzeichnis

Seite 1 - Probe Installation

ConnectorProbe TriggerAdjusting Nuts1⁄4” Thick Minimum1⁄4” Thick MinimumShould protrude at least 1⁄8” from disc surface.1⁄2” Wide3⁄16” DeepBracket to

Seite 2 - Mounting Memory Switch

12 MONTH LIMITED WARRANTYAuto Meter Products, Inc. warrants to the consumer that all Auto Meter High Performance products will be free from defects in

Kommentare zu diesen Handbüchern

Keine Kommentare

Auto-meter 6806 Bedienungsanleitung

Stöbern Sie online oder laden Sie Bedienungsanleitung nach Für das Auto Auto-meter 6806 herunter. Auto Meter 6806 User Manual Benutzerhandbuch

Inhaltsverzeichnis

Kommentare zu diesen Handbüchern