Auto-meter 880246 Bedienungsanleitung PDF herunterladen

INSTALLATION INSTRUCTIONS

IN-DASH ELECRIC TACHOMETER

2650-1138

QUESTIONS:

If after completely reading these instructions you have questions regarding the operation or installation of your instrument(s),

please contact Auto Meter Technical Service at 815-899-0801.

You may also email us at service@autometer.com.

Additional information can also be found at http://www.autometer.com/tech_faq.aspx

Calibration

IMPORTANT: This tachometer is factory calibrated to

operate on 8 cylinder engines. For 4 or

6 cylinder engines, it is necessary to

make the proper adjustments to adapt

this tachometer to your cylinder range.

Locate the black plastic plug covering the switch access hole.

The hole location is shown for 3

" and 3

" sizes. The 5" size

has a smaller access hole located in the upper left-hand portion

of the case. Remove the plastic plug covering the access hole.

use a small screwdriver or an unwound paper clip to change the

switch settings. Move each of the two switches to the proper

cylinder selection according to the diagram illustrated on the

right. Reinstall the plastic plug/cap into the access hole.

NOTE: This tachometer has an air core meter. With power off,

It is normal for the pointer to leave zero. When power

is applied, the pointer will move to the correct position.

Figure A.

4 CYL. - Switch One up, Switch Two down

6 CYL. - Switch One down, Switch Two up

8 CYL. - Both switches up

If you are unsure of your vehicle’s pulse(s) per revolution or specic

calibration requirements, contact Auto Meter’s Service Dept. at

(815) 899-0801, or go to www.autometer.com/hp/tectips for information.

Lens Cleaning

To prevent scratching the lens when

cleaning, use a mild, soapy solution to

clean. Wipe lightly with a soft cloth.

Note:

This tachometer operates on most early

model ignitions, factory electronic and high

performance electronic racing ignitions.

Switch is not visible from

from this angle, shown for

location only.

Access switch

through

access hole.

(Angle view through access hole)

Figure A

" SIZE SHOWN

1 2

4 CYL. / 2 PULSE

6 CYL. / 3 PULSE 8 CYL. / 4 PULSE

UP DN

DN UP UP UP

1 2

Inhaltsverzeichnis

Seite 1 - Lens Cleaning

INSTALLATION INSTRUCTIONSIN-DASH ELECRIC TACHOMETER2650-1138QUESTIONS:If after completely reading these instructions you have questions regarding the

Seite 2 - Mounting

Mounting1. Mount a 31/8" tachometer in a 35/32" dia. hole, a 33/8" tachometer in a 33/8" dia. hole and a 5" tachometer i

Kommentare zu diesen Handbüchern

Keine Kommentare

Auto-meter 880246 Bedienungsanleitung

Stöbern Sie online oder laden Sie Bedienungsanleitung nach Für das Auto Auto-meter 880246 herunter. Auto Meter 880246 User Manual Benutzerhandbuch

Inhaltsverzeichnis

Kommentare zu diesen Handbüchern

Verwandte Produkte und Handbücher für Für das Auto Auto-meter 880246